|
Make
|
Hunter
|
Model
|
31
|
|
Hull Type
|
Fin w/spade rudder
|
Year
|
1987
|
|
LWL
|
26.25 ft
|
LOA
|
31.33 ft
|
|
Displacement
|
9,900 lb.
|
Beam
|
10.92 ft
|
|
Ballast
|
4,200 lb.
|
Draft
|
4 ft
|
|
Water Tank
|
33 gal
|
Headroom
|
6 ft 3 inches
|
|
Fuel Tank
|
18 gal
|
Holding Tank
|
20 gal
|
|
Engine Make
|
Yanmar
|
Engine Model
|
2gm20F – 16 hp
|
https://www.sailboatlistings.com/view/110253
More photos: https://drive.google.com/drive/folders/1BAfzwRVX8tAoyqbBZ_A33L0gY-tAzRYw
Specifications:
- Main sail (full battens - very good condition)
- Jib/Genoa sail (furling - very good condition)
- Whisker pole
- 110v shore power marine A/C and thermostat (working fine)
- 12v refrigerator (working fine)
- VHF marine radio ICOM IC-M422 (working fine)
- Origo alcohol stove and oven. (2 burner stove, 1 burner oven)(working fine)
- Yanmar 2gm20F 16 hp diesel engine (working fine)
- 200 watt solar panel and MPPT controller
- 2 x 100 Ah LiFePO4 marine battery (Renogy Smart Bluetooth)
- 2 x deep cycle lead acid engine starter and backup batteries (Deka marine 80 Ah and 65 Ah)
- 110 V 30A battery charger (3 station)
- Garmin GPSMap 741xs chart plotter (working fine)
- Raymarine EV-100 wheel auto pilot (New) it just need to be installed by owner.
- 1:4 Scheafer soft boom vang
- Maxell deck winches (operates well)
- Dinghy davit and solar panel
- Zodiac Cadet 230 Roll Up Roll-Up inflatable dinghy (very good shape)
- Honda BF 2.3 outboard engine (year: 2022 - very low hours)
- Dodger/Bimini
- Cockpit cushions
- U.S. Coast Guard documented vessel
- Located at West River / Chesapeake Bay
- All marina fees are paid until 31 March 2026 if the new owner wants to keep the boat in the marina.
Upgrades and maintenance:
- Shaft seal was replaced (2020)
- Bluetooth audio system installed (2020)
- Reef line rollers and outhaul aluminum sheaves are replaced (2021)
- Sails (Main and Jib) are inspected, repaired and washed by Ulman Sails (2021)
- Bottom sanded and paint applied (2021)
- All sanitation hoses are replaced, and Jabsco Y valve are renewed and relocated (2022)
- Holding tank cleaned and deck plate is replaced. KUS gauge sensor and display installed (2022)
- Doger clear screens are replaced (2022)
- Control head forward and reverse gear on the steering pedestal has been replaced (the new one is cast aluminum) (2022)
- New Onyx DBX life vests 4 pack (2022)
- A/C water pump base and intake hose are replaced (2023)
- 2 lead acid Deka marine battery have been replaced (2023)
- Added station swivel cam cleat block for furling lead line (2023)
- Replaced water tank inspection deck plates (Beckson 6) (2023)
- Engine water intake filter gasket has been replaced and fixed broken bolt (2023)
- Installed new reef 1 and reef 2 lines (2023)
- Installed custom dinghy davit (2023)
- Installed new Spinlock XTS Double clutches (4 starboard, 4 port side) (2023)
- Bottom power washed, sanded and painted 2 coats (2023)
- Installed 200 watt solar panel (2024)
- 20 amp Renogy solar panel MPPT controller (2024)
- 2 x 100 Ah Renogy Smart LiFePO4 marine battery (200 Ah) (2024)
- New electric panel and 2 x Blea Sea switches for house battery abnk (2 x LiFePO4) and engine starter battery battery bank (2 x lead acid) (2024)
- Installed NavPod to the helm for electronic chart plotter and auto pilot control unit (2024)
- Installed rocker switches into the electric control panel (2025)
- 100A digital power monitoring LCD display for battery banks (2025)
- Bottom power washed, sanded and painted 2 coats (2025)
- Installed Scheafer 1:4 soft boom vang (2025)